INFINITY 8 USER MANUAL, MAINTENANCE GUIDE & LOG BOOK
Approved Document No: GLT-201-7-2
PAGE 4
Issue: 1.2 Authorised: Date: 27/3/2012
4. PANEL INDICATIONS & CONTROLS
Two levels of control are available to the User(s) of this Fire Alarm Panel.
4.1 GENERAL CONTROLS
When the Panel is in its Normal state, the indicator lights on the front of the enclosure give a
comprehensive overview
of the System’s current status. Any Fire and Fault conditions are clearly
displayed, and any disablements highlighted. For detailed descriptions of what each indicator means,
please refer to the table on the opposite page.
The only functions that can be performed by the User when the Panel is in its Normal state are:
Overriding any Delays, which may have been programmed into the Panel by pressing the
Override Sounder Delay button.
Putting the Panel into the Accessed state
– see below.
4.2 ACCESSED CONTROL (AVAILABLE TO AUTHORISED USERS ONLY)
To avoid unauthorised changes to critical parts of the Fire Alarm System, controls such as silencing
the Sounders, resetting an Alarm condition and implementing Disablements are only accessible via a
secure method of entry which puts the panel into the Accessed state.
To put the Panel into the Accessed State:
Entre the access code (1245) then press
. To exit
accessed state press
three times. If the wrong code is entered three times, then the
LED display
will light a combination of LED’s. If this happens you will need to contact GLT Exports for
the code.
Changing the Access Code
1. Enter the current access code and press
(control Enable lit)
2. Press
for 3 seconds panel will beep
3. Re-type the access code and press
4. Type the new code
5. Press
for 5 seconds
6. The will give a confirmation beep. New code is active
Information on how to use the accessed control can be found on Pages 8 to 11 of this User Manual.
