English - 3
IB v3.0.0 2021
© 2021 ZES - All rights reserved
•
Charging Station bottom must be at (or above) the ground level.
•
Adaptors or conversion adapters are not allowed to be used. Cable extension sets are not
allowed to be used.
•
The allowed current value of the service socket is maximum 10A.
•
This charging station is floor mounted.
WARNING: Never let people (including children) with reduced physical, sensory or men-
tal capabilities or lack of experience and or knowledge use electrical devices unsupervised.
CAUTION:
This vehicle charger unit is intended only for charging electric vehicles not
requiring ventilation during charging.
IMPORTANT SAFETY INSTRUCTIONS
Read carefully all the instructions before starting in order ensure properly
installation of the charge point.
Charging station is designed for installation in outdoor and indoor usage. For each of condition,
the station must be installed safely and proper protection should be ensured.
•
Charging station should be installed in areas where there is no risk of explosion.
•
Charging station should be installed in areas where there is no risk of falling objects around
which may damage the station.
•
The installation surface of the station should be withstanded against the physical and
mechanical forces.
•
The charging station should not be installed near areas where water or any liquid can penetrate
into the unit.
•
Charging station is designed for charging modes in IEC 61851, it should not be used for
anything other than this.
•
Do not modify the charging station which will cause rejection of warranty and responsibility
of Vestel.
•
Electrical safety regulations should be followed according to the county which the installation
is done.
•
There should not be made repairs when the unit is powered.
•
Only qualified technician should have access to electrical parts inside the charging station.
•
The installation should be checked periodically by qualified and trained technician.
•
The station should not be used if the enclosure or charging socket/plug is cracked or damaged.
•
The charging station has TYPE 2 AC outlets to be used for mode 3 charging. Also the charging
station has optional schuko socket outlets to be used for mode 1 charging.