Super User
Betapack 4 has a number of hidden functions, located in the Super User Menu. The super user menus can only be
accessed from the Default mode (no LEDs lit). To enter Super User press and hold the ‘Up & Down’ Arrows together
and press and hold the ‘Mode’ button for 5 seconds. All the mode LEDs will flash to indicate Betapack 4 is in super
user mode.
The ‘Up & Down’ Arrows are used to cycle through the various super user functions. Pressing the ‘Mode’ button at any
point will revert to normal operation. If no buttons are pressed after 20 seconds the unit will automatically revert to
normal operation.
Click to find out more about the Super User functions...
Lock
Reset
Firmware Version
Temperature
RDM
Temperature
Press the ‘Up & Down’ Arrows until the temperature is shown in the display, shown as xxxC, where xxx is the
temperature in Centigrade. The ‘Enter’ button has no function in this mode.
RDM
To enable or disable RDM (Remote Device Management) functionality
on the DMX control port, press the ‘Up & Down’ Arrows until “ron” or
“rof” is displayed. The ‘Enter’ button toggles this setting between “ron”
(RDM enable) and” rof” (RDM disabled).
Lock
Press the ‘Up & Down’ Arrows until the display shows “LOC”. Press ‘Enter’ to confirm this action. Betapack 4 will revert
to the Default mode. Pressing the ‘Mode’ button now will only cycle between Manual Control and Default Mode.
If Super User is entered when Betapack 4 is locked, only the unlock function will be available. The display will show
“UNL”. To unlock Betapack 4, press and hold the ‘Enter’ button for 5 seconds. Betapack 4 will unlock and exit super
user returning to the Default mode.
Reset
Press the ‘Up & Down’ Arrows until the display shows “rset”. Press ‘Enter’ to confirm. The display will flash briefly to
confirm this action. Betapack 4 will be reset to its default settings, shown in the table below:
Zero 88 - Betapack 4 - Page 11 of 12
Printed: 26/04/2021