ZERO-X swift+, User Manual

Page: 13 / 28

11
4.6 FLIGHT SAFETY
Before flying your Swift+ make sure that you are in a safe setting. CASA
restrictions regarding flying drones require the drone to be no closer than
5.5kms from any airport or airfield while flying. Drones should also not be
flown over populated areas or any closer than 30 metres from vehicles,
people or animals.
It is also required that you check your surroundings before taking off making
sure there are no obstacles or dangers in the area including overhead
power lines and large bodies of water. If there are hazards present in your
intended area of flight, please consider an alternative location.
4.7 SYNCING YOUR SWIFT+ DRONE
1. Unfold the Swift+ drone by extending the front legs first and then the
back legs.
2. Press the ON/OFF button on the top of the drone to turn the drone on,
the LED light of the drone will blink a blue colour (front) and a red colour
(rear).
3. Extend the arms of the controller downwards, the controller will make a
beeping sound and the LED indicator will Power On the controller.
4. Move the left control stick to the upside for 1 second and then move the
left thumb stick to the downside for 1 second, the control will beep and
the LED light of drone will stop blinking. The LED will change to solid
blue in front and solid red in rear
(Fig 1) .
5. Please ensure that you have connected to your smartphone via WIFI
before flying the Swift+ drone. Please refer to page 15.
6. Place the drone on a flat surface, and hold the left and right control sticks
inward & downward (left stick 5 o'clock and right stick 7 o'clock positions)
for 3 seconds. The indicator on the drone will change from constant light
to quick flashing lights. When the LED light of the drone remains solid
again, this means that the drone has been calibrated successfully
(Fig 2) .
NOTE:
• Please repeat step 6 before every flight.
• Please pair the controller frequency within 5m of the drone to avoid
interference with other signals.
(Fig 1) (Fig 2)