Zero Motorcycles 2014 ZERO S, Owner'S Manual

Page: 62 / 128

General Operation
4.12
Quick Charger LED Indicators
A.
Ammeter
The Ammeter LED is an amber indicator that indicates
the amount of current output and should gradually
ramp down from “IIIIII” to “I”.
B.
80% Charge
The 80% Charge LED is an amber indicator. If it is on
solid, the bulk charge phase is complete, 80%
charged. Charger is now in absorption phase. If the
indicator is flashing, there are two issues that can
cause this to occur:

The charger and BMS are balancing.

The BMS is cutting off the charge because one or
more cells have reached maximum voltage.
C.
100% Charge
The 100% Charge LED is a green indicator. If it is on
solid, the charging is complete and the charger will
enter maintenance mode. If it is flashing, the
absorption phase is complete and the charger is in
finish phase.
D.
AC ON
The AC ON LED is an amber indicator. If it is on solid,
the AC power is good. If it is flashing, the AC voltage
is low. Check for proper voltage, and if an extension
cord is being used, verify that it is the correct length.
Maximum length is 25 ft. (7.6 m) 12 AWG.
E.
Fault
The Fault LED is a red indicator which indicates there
is a charger error. If it is flashing, reset the charger
and see
“Troubleshooting”, on page 6.1 .
CHAdeMO Charger
Your Zero motorcycle can utilize an optional quick charging
CHAdeMO charger system. A CHAdeMO charger can
charge your motorcycle in about one hour. For additional
information contact your Zero Motorcycles dealer.