background image

•This air-conditioning unit is a sealed unit containing a fluorinated gas. For information on specific gas types and 

quantities, see the relevant label  on the device. Mark2 does not support users adding refrigerant themselves.

•Maintenance or repair of this equipment must be performed by a certified technician. 

•Product recycling must be performed in accordance with local regulations.

Note

All pictures in this manual are for illustration only. Your air conditioner may be slightly different depending on your model.

Notes on fluorinated gases

SAFETY PRECAUTIONS

CAUTION

Read This Manual

Inside you’ll find many helpful hints on how to use and maintain your air conditioner properly. Just a little preventive 
care on your part can save you a great deal of time and money

as well as extend the life of your air conditioner. You’ll find many answers to common problems in the troubleshooting 
tips - you should be able to fix most of them quickly before calling service. These instructions may not cover every 
possible condition of use, so common sense and attention to safety is required when installing, operating and main-
taining this product.

•Installation must be performed according to the installation instructions. Improper installation can cause water 

 leakage, electrical shock, or fire.

•Use only the included accessories and parts, and specified tools for the installation. Using non-standard parts can   

  cause water leakage, electrical shock, fire, and injury or property damage.

•Make sure that the outlet you are using is grounded and has the appropriate voltage. The power cord is equipped 

  with a three-prong grounding plug to protect against shock. Voltage information can be found on the side of the unit, 

  behind the grille.

•Install the unit on a flat, sturdy surface. Failure to do so could result in damage or excessive noise and vibration.

•The unit must be kept free from obstruction to ensure proper functioning and to mitigate safety hazards.

•DO NOT modify the length of the power cord or use an extension cord to power the unit. DO NOT share a single outlet 

  with other electrical appliances. Improper power supply can cause fire or electrical shock.

•DO NOT install your air conditioner in a wet room such as a bathroom or laundry room. Exposure to water can cause 

 electrical components to short circuit.

•DO NOT install the unit in a location that may be exposed to combustible gas, as this could cause fire.

•DO NOT operate a unit that has been dropped or damaged.

•Only use the included accessories and specified parts for installation. Using nonstandard parts can cause water 

  leakage, electrical shock, fire, and injury or property damage.

•DO NOT allow children to play with the air conditioner. Children must always be supervised around the unit.

•If the air conditioner is knocked over during use, turn off the unit and unplug it from the main power supply immedi

  ately. Visually inspect the unit to ensure there is no damage. If you suspect the unit has been damaged, contact a 

  technician or customer service for assistance.

•In a thunderstorm, the unit should be turned off to avoid damage to the machine due to lightning

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabil-

ities, unless they have been given supervision or instruction concerning use of the appliance by a person responsible 

for their safety.

•If the power cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons 

  in order to avoid a hazard.

•Prior to cleaning or other maintenance, the appliance must be disconnected from electricity.

•Do not install the appliance in a location that may be exposed to combustible gas. If combustible gas accumulates 

  around the unit, it may cause fire.

•Do not run the power cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not 

  route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.

•To reduce the risk of fire or electric shock, do not use this air conditioner with any solid-state speed control device.

•The appliance shall be installed in accordance with national wiring regulations.

•Contact the authorized service technician for repair or maintenance of this unit.

•Do not mix old and new batteries.

•Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.) batteries.

•Contact the authorized service technician for repair or maintenance of this unit.

•The air conditioner is not intended for use by young children or anyoneunable to operate it    

  independently.

•When using this unit in the presence of children they should always be supervised.

•If the power cord needs to be replaced, please contact our consumer service to find an autho

  rized technician.

•Electrical installation must be performed in accordance to national regulation standards by 

  qualified personnel only.

To prevent injury to the user or other people and property damage, the following instructions 

must be followed. 

CAUTION: 

This symbol indicates the possibility of injury or damage to property 

WARNING:

 

This symbol indicates the possibility of death or serious injury.

01

02

Summary of Contents for MARK 2 Series









Reviews: