Z3N/Z3NU/Z3NN/Z3NNU/Z3NW/Z3NWU 75-100
Installation
17
www.zepro.com
4
Installation
4.1
Frame
1. Mount the lift to the chassibracket. The number of
screws and theír placement depends on the type
of bracket used, see installation instruction for the
mounting kit in question.
2. Measure and mark the midpoint of the vehicle's
rear beam.
3. Check the A measure, if cut outs need to be
done in the rear beam, see marking Image 13.
4. Do the necessary cut outs from the rear beam
according to the illustrations with the installation
dimensions for the respective lift model. See
section 3.3
5. Attach the mounting jig, part no 74632TL för
Z3N 75, to the rear beam so that the respective
midpoint corresponds. Use clamps, screws or
spot weld.
6. Place the lifting frame under the vehicle's frame
and mount the lift arms at the eye of the jig. Use
ordinary bolts for the lifting platform.
The lifting frame must be parallel with the floor of
the vehicle body.
7. Tightly screw the lifting frame into the frame
attachments. If lift needs to be adjusted longitu-
dinally in the slot.Use 4 M14x45 10.9 (120 Nm)
per side.
NOTE!
Use washers on both sides of the fastening!.
Image 13. Measure and mark the mid-
point of the rear beam of the vehicle
Image 14. Attach the mounting jig,
part no 74632TL för Z3N 75
Image 15. Adjust the frame to the ideal height
under the frame. A car jack is a good tool.
Summary of Contents for Z3N 75-100
Page 2: ......
