Z 2500-130/150
28
Installation
www.zepro.com
2x M12x100 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x100 8.8
80 Nm
4.5.1
Underrun protection
1. Test the position of the underrun protection with-
out tightening the bolts to check that the statutory
dimensions are obtained. Adjust if necessary then
tighten the bolts with a torque wrench.
2. Fit the inner part of each bracket at one of four
heights. Select the height that meets the statutory
requirements, see section"3.2 Statutory dimensions
for underrun protection" on page 9. Use the cor-
rect bolts M12x100. Assemble without tightening
the bolts, see
Image 45
.
3.
Fit the outer part of each bracket at one of five
positions. Select a position that meets the statu-
tory requirements, see section "3.2 Statutory di-
mensions for underrun protection" on page 9.
Check carefully that there is no risk of the outer
part of each bracket colliding with any part of
the cylinders when using the lift’s functions. In
particular, check in relation to the cylinders’ hose
connections, especially when the outer part of the
brackets is installed a long way in.
m
WARNING!
Use the correct bolts M12x80. Assemble without
tightening the bolts. See
Image 48
.
4. Check that the installation meets the statutory
requirements.
5. Tighten all the bolts using a torque wrench.
Tightening torque: 80 Nm.
6. Fit the beam end caps, rotated so the logo is the
right way up, and press them firmly to secure. If
necessary, tap carefully with a rubber hammer.
Image 45.
T
he inner part of the brack-
ets can be fitted at one of four heights
Image 46.
T
he outer part of the brackets
can be fitted in one of five positions
Image 47.
F
it the beam end caps
Image 48.
I
nstalling underrun protection
133
193
241
301
617
667
717
767
817
Summary of Contents for Z 2500-130
Page 2: ......
Page 63: ...Z 2500 130 150 Specifications 63 www zepro com...
