Z 2500-130/150
22
Installation
www.zepro.com
4.2
Platform
1. Check that all included components are clean,
cleaning them where necessary.
2. Lubricate the metal bushings on the upper bearing
of the arms. Ensure that the small holes on the
inside of the bushings are filled with grease. See
illustration. Use Zepro lubricant or the equivalent.
Carefully lubricate the metal bushings on the
upper bearing of the arms. Ensure that the small
holes are filled with grease. After the platform
is fitted, lubricate all bearings via normal grease
nipples, see section "10 Lubrication and fluid
level check" on page 59.
NOTE.
3. Fit the platform to the arms using the supplied
shafts and screws. Tighten the bolts using a
torque wrench.
Tightening torque: 80 Nm.
4. Fit one of the tilt cylinders to the platform. Use
the supplied shaft and support wheel.
Make sure the cylinders are installed with the
grease nipples facing up.
NOTE.
Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
NOTE!
Lubricate the bushings
Image 29.
C
arefully lubricate the metal bushings
Image 30.
F
itting the platform to the arms
Image 31.
F
itting the tilt cylinder to the platform
Summary of Contents for Z 2500-130
Page 2: ......
Page 63: ...Z 2500 130 150 Specifications 63 www zepro com...
