12
www.zephyronline.com
FIG. J
2
1
3
5
4
Top duct covers
Top support frame
Bottom duct covers
Bottom support frame
Thick trim piece (top)
Thin trim piece (bottom)
cut trim piece
if necessary
11. *Secure top duct covers (with louver holes) to top support frame using (2) M4 x 8 truss head sheet metal screws.
(FIG. J, #1). Note: If using hood in “ducted mode” the top duct covers may be turned upside-down to hide the louver
holes.
12. Assemble top duct covers together using (3) M3 x 5 screws on each side. (FIG. J, #2). Larger screw hole openings
should overlap the smaller holes.
13. Assemble bottom duct covers together over top duct covers using (3) M3 x 5 screws on each side. Bottom duct
covers will rest on top of the hood body. (FIG. J, #3)
14. Insert the (2) thin trim pieces into left and right seams of bottom duct covers. (1 on each side) (FIG. J, #4)
15. Insert the (2) thick trim pieces into left and right seams of top duct covers. (1 on each side) (FIG. J, #5)
Note: Because less of the top duct covers will be exposed, it may be necessary to measure and cut the thick
trim pieces before installing them into the top duct covers.
* If using hood in recirculating mode you must install the air diverter plate before assembling the duct covers.
Turn to page 13 for instructions.
Installation –
Mounting the Hood
Summary of Contents for ZMD-E42AS
Page 2: ...www zephyronline com...
Page 21: ...19 Fan Curve Diagrams...
Page 26: ...www zephyronline com...
