![Zephyr Z-1443-B20 Instruction Manual Download Page 4](http://html1.mh-extra.com/html/zephyr/z-1443-b20/z-1443-b20_instruction-manual_931398004.webp)
_
English
_
INSTALLATION
1.
Take out all the packing. If there is a safe film over the oven, tear it off before use. Check
carefully for damage. If any, immediately notify the dealer or send the appliance to the
authorized service center.
2.
Microwave ovens must be placed under dry and non-corrosive environments, kept away
from heat and humidity, such as gas burner or water tank.
3.
To ensure sufficient ventilation, the distance of the back of microwave to the wall should
be at least 10 cm, the side to the wall should be at least 5 cm, the free distance above the
top surface at least 20 cm, the distance of the microwave to the ground should be at least
85 cm.
4.
The position of the oven shall be such that it is far from the TV, Radio or antenna as it
may cause disturbance. The distance should be more than 5m.
5.
The appliance must be positioned so that the plug is accessible, and must ensure a good
grounding in case leakage, ground loop can be formed to avoid electric shock.
6.
The microwave oven must be operated with the door closed.
7.
The microwave oven must not be placed in a cabinet. The microwave oven is intended to
be used free standing.
8.
As there is manufacturing residue or oil remained on the oven cavity or heat element, it
usually would emit slight odor, even a slight smoke. It is normal case and would not occur
after several using several times, keep the door or window open to ensure good ventilation.
So it is strongly recommended to place a cup of water on the turntable, setting at high
power and operate for several times.
9.
To keep the microwave oven at a distance from the wall, it is necessary to install a
distance limiter.
1)
Push the Distance Limiter in the given direction;
2)
Make sure the Clasp A is secured to Hole A;
3)
Insert the Clasp B and the Clasp C into their respective square holes.
Hole A
Clasp C
Clasp B
Hole A
Clasp A
Push Distance Limiter
into this direction.
Secure Clasp A
to Hole A
Distance
Limiter