Zephyr Okeanito COK-E36CBGX, Use, Care And Installation Manual

Page: 16 / 56

16 Okeanito Use, Care, and Installation Guide
O K E A N I TO
WA L L
D E S I G N E R
Installation Instructions
Mounting the Range Hood
remote blower
knockout
electrical
knockout
7/8”
1-7/8”
9-15/16”
C/L
FIG. E FIG. F
10-9
/16
”
Upper duct cover
attachment screw
locations
Back View
10. Attach wall bracket to wall by (3) M4*38 screws with washers. NOTE: Wood blocking may need to
be added behind the drywall if no studs are present. Wall anchors may also be used but check
with local codes for compliance. Failure to use suitable wall anchors and screws to hold the weight
of the hood could result in personal injury or damage to the cooking surface or counter.
11. Lift hood onto wall bracket. The lip at the back of the hood body will rest between the wall and the
top lip of the wall bracket. Secure hood body in place by (2) M4*38 screws though bottom section
of interior of hood body. FIG. E.
12. Place telescopic duct covers on top of hood.
13. Run duct work from ceiling to motor collar and seal all joints with certified aluminum duct tape
and install electrical wiring. FIG. F.
14. Attach upper (inner) duct cover to ceiling bracket by (2) M4*8 screws. FIG. E.
15. Attach utensil rail to hood canopy by (3) set screws (pre-installed into rail) using the provided Allen
key. FIG. G. A small hole has been pre-drilled into the canopy to provide a starting point to attach
the first utensil rail post. After the first post is lined up with the hole, gently slide the rest of the rail
onto the canopy. Be careful not to scratch the stainless of the canopy while installing the utensil
rail.
Front Back
Set screw
FIG. G