13
1. Disconnect single blower wire.
2. Remove support screw from top of hood near
the back. Remove 2 screws holding blower plate
to hood and pull blower towards front of hood to
release from internal bracket.
3. Unscrew (4) screws holding blower to blower
plate and remove blower. Remove metal
damper. Discard single blower plate.
4. Picture of PBD-1100A dual blower kit.
5. Use the blower removed from the single blower
plate and install it into the dual blower plate.
DUAL BLOWER INSTALLATION*
*IMPORTANT: Dual blower and heat lamps may only be used together in 36” and 42” models.
30” models will only accommodate one or the other, not both at the same time.
Installation –
PBD-1
100A
Dual Blower
6. Connect 9 pin male molex connector from blower
to 9 pin female molex connector on dual blower
capacitor box.
Summary of Contents for AK7000AS
Page 2: ...www zephyronline com...
