1.
Carry handle
2.
Thermostat knob
3.
Power switch
4.
Cord storage
5.
Radiant fins
6.
Castor
ASSEMBLY INSTRUCTIONS
The heater is packaged with the feet unattached. You must attach them before operating the heater.
WARNING: Do not operate without feet attached. Do operate the heater only in upright position (feet on the
bottom, controls on the top), any other position could create a hazardous situation.
1.
Place the radiator body upside-down on a scratch-free location, make sure it is stable and will not fall.
2.
Screw off the wing nuts from the U-shaped bolt provided, attach the U-shaped bolt to the U-facing flange between
first and second fins (near the front cover).
3.
To attach the castor mounting plate to the radiator body, you should insert the threaded ends of the U bolt in the
holes on the castor mounting plate.
4.
Screw the wing nuts back to the U bolt and fasten the wing nut properly.
Note: do not over tighten, which may cause the damage of radiator flange.
5.
Screw off spherical nut from the castor, align the shaft to the hole of the castor mounting plate, insert in, and screw
on the spherical nut.
6.
Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of the rear castors.
Note: the rear castors must be mounted between the end two fins.
HOW TO USE
1.
Before using the heater, make sure that it is on a flat and stable surface. Damage may occur if it is placed on an
incline or decline.
