Zephir ZFL34M, Instruction Manual

Page: 28 / 38

Tip: To prepare for threading electrical wires through downrod, apply small piece of electrical tape to the ends of electrical
wires-this will keep the wires together when threading them through the downrod.
Loosen yoke set screws and nut at top of motor housing. Remove pin and clip from downrod (if you have not already done
so). Slide downrod through canopy.
Tread electrical wires through downrod and pull extra wire slack from the upper end of the downrod.
Place downrod into the motor housing yoke and ew-insert pin and clip that were previously removed. Tighten yoke set
screws and nut securely. Lower canopy to motor housing.
Insert the electrical cables inside the
downrod. Insert downrod into the top of the fan
motor. Lock the bracket by applying the
safety hook through the ends of the
hole
Apply the cotter pin to prevent the
screw from pulling out by itself. Lock the downrod definitively by
applying the safety screw in the side
hole Apply the safety pin in the upper end
of the downrod.