Zephir ZFL34M, Instruction Manual

Page: 27 / 38

Installation requires these tools:
Screwdriver, flat-head screwdriver, adjustable pliers or wrench, stepladder,
wire cutters and rated electrical tape.
Assembling
If you wish to extend the hanging length of your fan, you must remove the hanging ball from the 6 inch downrod provided to
use with an extended downrod (included) . (If you wish to use the 6 inch downrod, please proceed to instructions below.)
To remove hanging ball, loose set screw on hanging ball and remove pin and clip. Lower hanging ball and remove stop pin.
Slide hanging ball off the original downrod A and slide it down the longer downrod B (the top of the downrod should be noted
as having a set screw hole; use this hole when setting the set screw). Insert stop pin into top of extended downrod and raise
hanging ball. Be sure stop pin aligns with slots on the inside of the hanging ball,
tighten set screw securely.