12
4) Disconnect the charger from the power source before closing or opening the connection
to the battery/power tool/device.
5) Keep the charger clean and away from humid environments and rain. Do not use the
charger outdoors. The ingress of dirt or moisture will increase the risk of electric shock.
6) The charger can only be used to charge the original battery. If it is charged for other
batteries, it may cause personal injury and cause fire.
7) Avoid mechanical damage to the charger. Otherwise, it may cause an internal short
circuit.
8) Do not use the charger (e.g. paper, textiles) on the surface of flammable materials.
9) If the equipment is damaged, it must be replaced by the manufacturer, customer service
personnel or personnel with the same or similar qualifications to prevent danger.
10) At the time of delivery, the battery of this product is not fully charged. Therefore, the user
must fully charge it before using it for the first time. For the first charge cycle, we
recommend that the user charge for 2-3 hours. Insert the battery into the base and plug
the charger into the power outlet.
11) After the battery is fully charged, unplug the charger from the power supply and the
device.
12) Charging time is about 2-3 hours after the battery is completely discharged. Do not
charge the battery for an extended period as this will damage the battery.
Assembly
Please check that the pruning shears, wires and batteries are clean and dry, and then follow the
steps below to assemble:
1) Remove the harness/backpack from the plastic carrying case, connect the plastic buckle
and fasten the waist strap.
2) Place the battery pack in the battery compartment and secure the. Make sure that the
connector is facing right if you are right handed
3) Double-check to make sure there is no one around, the user should maintain a safe
distance from the pruning shears and ensure that the wire and battery are firmly
connected.
4) The other end of the wire is tightened with the pruning shear connection seat
5) Fasten the waist strap.
6) Check the opening and closing position of the pruning shears
7) Grip the handle with your hands
8) Left-handed users, please convert the battery pack and the wires to be connected on the
left.
9) Turn on the power switch, pull two scissors to the trigger in a row and open the scissor
head. You can start the operation.