GB-10
PSJ2310
8. Operation
STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine
starts.
1. Feed fuel and chain oil into their respective tanks
and tighten the caps securely.
(2)
(1) Fuel
(2) Chain oil
2. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.
3. Push the primer several times until overflown fuel
flows out in the clear tube.
4. Move the choke lever to the closed position.
(1) Choke lever
(2) Close
(3) Open
(4) Primer
5. Set the stop switch to the “RUN” position.
Place the unit on a flat place.
Keep the cutting head clear of everything around
it.
(1)
(1) Stop switch
6. While holding the unit firmly, pull out the starter rope
quickly until engine fires.
IMPORTANT
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
7. Move the choke lever downward to open the choke.
And restart the engine.
8. Allow the engine to warm up for a several minutes
before starting operation.
NOTE
1. When restarting the engine immediately after stop-
ping it, leave the choke open.
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
STOPPING ENGINE
1. Release the throttle trigger and run the engine for a
half minute.
2. Shift the stop switch to the “Stop” position.
IMPORTANT
• Except for an emergency, avoid stopping the engine
while pulling the throttle trigger.
Checking oil supply
• After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown
in the figure.
(1) Chain oil
01-PSJ2310_GB_209＿三.indd 10
12.9.12 1:09:30 PM
