Zenoah GZ3500T, Workshop Manual

Page: 25 / 56

English –
25
Safety equipment
Fig 36
5
Hook the throttle actuator rod E to the throttle, put
the spring back onto the throttle. Place the throttle
and the spring in the handle part as shown in
figure 36. Refit the electrical cables H in the slot as
shown in figure 36.
Fig 37
Fig 38
Fig 39
6
Place the throttle as shown in figure 37. Put the
handle bar in the handle unit.
7
The handle part is fastened with the screws A, see
figure 39. Note! Hold the throttle lockout down so
that the spring doesn’t jump out when the handle
part is assembled.
8
Refit the guide F, see figure 39. Fasten the air filter
holder with the air filter, then fasten the air filter
cover. Make sure the lock is open when you push
the cover into place.