Square TMD
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
28
dependent LED lighting will be determined by the value of this object (LED off at 0%
and on at any other level).
The parameters for this function are:
Step
: defines the dimming step (“100%”, “50%”, “25%”, “12.5%”, “6.25%”,
“3.1%” or “1.5%”) to be sent to the light dimmer with every increase /
decrease order.
Note
:
since dimmers typically do not apply the new light level immediately
(i.e., the step regulation is performed progressively) and since Square TMD
sends an order to interrupt the step dimming once the user releases the
button, it is advisable to configure a step of 100%. This way, the user can
perform any dimming step by simply leaving the button pressed and then
releasing it without needing to make successive button presses
.
Action
: assigns each of the two buttons the order to be sent:
“Left=Off; Right=On”.
“Left=On; Right=Off”.
Note
:
this parameter will remain hidden unless having selected “Every button
pair is configured separately” in Action of the pair buttons (see section
2.3.1)
.
LED illumination control
: analogous to the homonymous parameter for the
“Switch” and “Two Objects (short press / long press)” function (see above).
Shutter
Figure 27
Pair Buttons – Shutter.
The move orders will be sent through “
[Btn] [PX] Shutter - Move
”, while the stop
orders will be sent through “
[Btn] [X] Shutter Stop/Step
” (for Standard type) or “
[Btn]
[PX] Shutter - Stop
” (for Hold & Release type).
