Roll-ZAS
http://www.zennio.com
Technical Support:
http://zennioenglish.zendesk.com
13
Figure 7
.
ZAS Remote Control
The outer (left/right) buttons on rows 2-5 in the remote control perform the same
actions as the remaining 8 buttons that can be found on the touch panel. Additionally,
the inner 8 buttons of rows 2-5 (S1-S6 and F1-F2) and the buttons on the lower row
allow performing certain direct functions:
Buttons S1-S6
: permit sending run orders for the scenes (up to 6)
parameterised under Scenes, in the “Remote control” tab (see section 3.2).
The remote control only permits sending run orders to the bus; sending scene
save orders is not possible.
Buttons F1 and F2
: permit sending binary communication objects, according
to the ETS configuration (values “1”, “0” or an alternation of both).
Buttons “Comfort”, “Standby” and “Economic”
:
permit a direct activation
of the special climate modes: Comfort, Standby and Economic. Prior to
making use of these buttons, it is necessary to have the special modes
enabled from ETS, either independently or linked to one of the two
thermostats implemented by Roll-ZAS.
Button “Switch off”
: a short press on this button turns the backlight of the
display off. A later press on any of the touch buttons or on the remote control
will set the display back to the configured light level.
In addition to the execution of the action configured for the corresponding touch button,
whenever a button on the remote control is pressed, the corresponding LED on the
touch panel will flash as if the touch button were actually being pressed.
Note
:
presses over the central touch area cannot be emulated from the remote control
.
Action buttons
Scenes
Special functions
Climate control
Display
