Zennio Linecoupler
Technical Support:
http://zennioenglish.zendesk.com
6
1.2
INSTALLATION
Figure 3
Element Diagram
As shown in Figure 3 each of the two KNX lines to be coupled must be connected to
one of the two KNX bus connectors available (6, 11). After the connection, the line
coupler can be conveniently mounted on the DIN rail by the usual procedure.
This device does not need any external power supply since it is entirely powered
through the main KNX bus (6).
Note
:
each line (or line segment) being coupled requires a dedicated power supply. No
power pass from one line to another is performed.
The programming button (10) shown in Figure 3 may be pressed to set Linecoupler in
programming mode
. After a short press, the programming LED will light in red.
The behaviour of the additional LEDs and the manual function button will be described
in section 2.2.
For detailed information about the technical features of Linecoupler, as well as
information on security and on the installation process, please refer to the
Datasheet
included within the original packaging of the device and also available at
6
11
10
5
9
8
7
4
3
2
1
1.
Main line status LED.
2.
Main line traffic LED.
3.
Group address filter table status.
4.
Manual function button.
5.
Programming LED.
6.
Main line KNX connector.
7.
Secondary line status LED.
8.
Secondary line traffic LED.
9.
Physical address filter table status.
10.
Programming button.
11.
Secondary line KNX connector.
