KLIC-MITTE
Technical Support:
5
Figure 2.
Connecting KLIC-MITTE to the Ecodan unit
Important
:
KLIC-MITTE is designed for FTC5 control systems. For other control
systems, that many functions are disabled must be taken into account. In addition,
certain parameterisations made in the device can be ignored.
For detailed information about the technical features of KLIC-MITTE, as well as on
security and installation procedures, please refer to the device
Datasheet
, bundled in
the device packaging and also available at
START-UP AND POWER LOSS
Depending on the configuration, some specific actions will be performed during the
device start-up. The integrator may set up an initial status to be sent to the unit after
the bus power recovery, and whether certain objects should be sent to the bus after the
power recovery, as described in later sections.
On the other hand, when a bus power failure takes place, the device will interrupt any
pending actions, and will save its state so it can be recovered once the power supply is
restored.
C I
1 2 C
1 2 C
1 2 C
14
11
□
3
9
DDv3
MITTv2
Común
Común
