KLIC-DA LT
Technical Support:
http://zennioenglish.zendesk.com
16
[Temperatures] Leaving Water
: two-byte object that reflects the current
temperature of the leaving water flow, as reported by the Altherma LT
system.
[Temperatures] Leaving Water (PHE)
: two-byte object that reflects the
current temperature of the plate heat exchanger (PHE) leaving water flow, as
reported by the Altherma LT system.
[Temperatures] Outdoor Temperature
: two-byte object that reflects the
current outdoor temperature, as reported by the Altherma LT system.
[Temperatures] Refrigerant
: two-byte object that reflects the current
temperature of the refrigerant, as reported by the Altherma LT system.
Whenever the Altherma LT system notifies a temperature change, KLIC-DA LT will
automatically send the corresponding object to the KNX bus.
3.1.1.5
ACTUATORS (STATUS)
No additional parameter configuration is required for this function.
If enabled, the following communication objects will be available:
[Actuators] BUH: Step 1
: one-bit object that reflects the status of the Backup
Heater Step 1 (“1” = turned on; “0” = turned off).
[Actuators] BUH: Step 2
: one-bit object that reflects the status of the Backup
Heater Step 2 (“1” = turned on; “0” = turned off).
[Actuators] Compressor
: one-bit object that reflects the status of the
compressor (“1” = turned on; “0” = turned off).
[Actuators] Pump
: one-bit object that reflects the status of the pump (“1” =
turned on; “0” = turned off).
Whenever the Altherma LT system notifies a change in the status of the above
actuators, KLIC-DA LT will automatically send the corresponding object to the KNX
bus.
