ZENN
iO
AVANCE Y TECNOLOGÍA
vwww.zennio.com
19
19
These parameters are:
Minimum time between sendings:
allows setting the minimum time, in seconds,
which should pass between two consecutive sendings of the object
“Instant Power”, no
matter if they are cyclic sendings or sendings motivated by a change of the value. Valid
times are [5-255] seconds. This minimum time between sendings will only take effect if a
value other than 0 is parameterized for fields
“Cycle time” or “Send on Value Change”.
Cycle time:
allows setting the period for sending the object
“Instantaneous Power”, in
seconds (0
– 255). In other words, every how much time these values will be sent to the
KNX bus. Note that if the value specified here (x) is lower than the minimum time between
sendings (y), the latter will prevail, resulting in sendings taking place only every
“y”
seconds.
If “0” is parameterized for “Cycle time”, no periodic sending of the associated
communication object will take place.
Send on value change:
allows setting a certain value so that whenever a change in
the instantaneous power greater than that value is detected, a new sending of the
corresponding communication object
(“Instant Power”) will happen. If there is no need of
this feature, just let this field be 0.
Note that if a value other than 0 is set for fields
“Cycle time” and “Send on value change”,
the object
“Instant Power” will also be sent to the KNX bus whenever the value “1” is
received through the communication object
“Global Request”.
Peak Power Values
. This section allows the configuration of the sending of power peaks,
that is, the highest instant power values detected during the last hour, day, week or month.
Please note that
–if enabled– hourly peak values can be sent not only at the end of the last
hour but also
before
the end, by means of the parameters
Minimum Time between
sendings
,
Cyclical sending
and
Send on value change
, which behave the same way as
described above for
“Instant power”, making it possible to inform the bus about how the hourly
peak value changes throughout the hour. Regarding daily, weekly and monthly peak values,
they can be sent not only at the end of the day / week / month, but also periodically (with their
