© Zennio Avance y Tecnología S.L.
Edition 3
Futher information
Page 4/4
SAFETY INSTRUCTIONS AND ADDITIONAL NOTES
•
Installation should only be performed by qualified professionals according to the laws and regulations applicable in each cou ntry.
•
Do not connect the mains voltage nor any other external voltage to any point of the KNX bus; it would represent a risk for the ent ire
KNX system. The facility must have enough insulation between the mains (or auxiliary) voltage and the KNX bus or the wires of other
accessories, in case of being installed.
•
The facility must be equipped with a device that ensures the omnipolar sectioning. Installation of a 10A mini -circuit-breaker is
recommended. To prevent accidents, it must remain open in case of manipulation of the device.
•
The device has a short-circuit protection fuse that, in case of activation, should only be rearmed or replaced by the Zennio technical
service.
•
This device contains a security short-circuit proof transformer.
•
Once the device is installed (in the panel or box), it must not be accessible from outside.
•
For indoor use only
•
Keep the device away from water (condensation over the device included) and do not cover it with clothes, paper or any other material
while in use.
•
The WEEE logo means that this device contains electronic parts and it must be properly disposed of by following the instructions at
http://zennio.com/weee-regulation.
•
This device contains software subject to specific licences. For details, please refer to http://zennio.com/licenses.
INSTALLATION AND CONNECTION
•
This device must be exclusively installed in a 35mm DIN rail
inside a distribution box or an electrical panel.
•
Ensure suitable ventilation to prevent the temperature from
exceeding the permissible range.
•
Main power must be connected to L, N and ground
terminals.
•
The coil integrated bus output must be connected through a
standard KNX connector.
•
The additional output connection must be connected
according to the polarity indicated on the housing.
Attaching ALLinBOX 1612 to DIN rail:
Removing ALLinBOX 1612 from DIN rail:
Figure 3: Mounting ALLinBOX 1612 on DIN rail
