206-3678
P A G E 7
Hook Up An Over-The-Air Antenna
Mini glossary
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack (Antenna/Cable). They are usually about an inch long
with two screws on one end and a round opening with a wire sticking out on the other end.
Connect an off-air antenna to the
Presentation TV
If you have a 75 ohm RF cable, then you
don’t need any adapters!
A 300 to 75 ohm adapter is not included with
the Zenith Presentation TV.
300 TO 75 OHM
ADAPTER
Flat Wire
(300 ohm)
Antenna
300/75 ohm
Adapter
TV Back
Video
In
S-Video
In
M.P.I.
Matrix
Out
R- Audio - L
In
S-Video
Out
Antenna
Cable
TV Back
Video
In
S-Video
In
M.P.I.
Matrix
Out
R- Audio - L
In
S-Video
Out
Antenna
Cable
RF Coaxial Wire
(75 ohm)
Antenna
Locate the Antenna/Cable jack on the back of
the Presentation TV.
Connect the cable that runs from the wall
directly to this jack, according to one of the
diagrams shown to the right.
Remove the back of the remote and put in two
AAA batteries.
Plug in your TV. Do not plug it into a switched
outlet. Your Entertainment Machine is designed
to operate on standard current, 120-volt 60
Hertz AC. Do not attempt to operate it on DC
Current.
Go to page 14 to Auto Program the
Presentation TV.
back of
remote
1
2
3
4
5
