Zenith P42W24P, Installation And Operating Manual, Page: 19 / 36

19
- If the picture isn’t clear after auto adjustment and especially if characters are still jittery, adjust the picture phase
manually.
- You can only adjust
V-POSITION/H-POSITION
in DTV (480p,720p,1080i), COMPONENT (480p,720p,1080i), RGB1 (PC)
modes.
Initializing (Reset to original factory value)
Initializing (Reset to original factory value)
- To initialize the adjusted value, select RESET with the D
/
E button in step 3 of ‘picture phase adjustments’ and
then press the
G
button.
Auto
Auto
Adjustment (RGB1 (PC) mode only)
Adjustment (RGB1 (PC) mode only)
- Automatically adjusts picture position and minimizes image shaking.
- If the image is still not correct, your Monitor is functioning properly but needs further adjustment.
1. Press the AUTO CONFIG. button to run Auto configure.
• If the position of the image is still not correct, try Auto adjustment again.
2. If picture needs to be adjusted more after Auto adjustment in RGB1 mode, you can
manually adjust the image's V-POSITION / H-POSITION and PHASE .
Screen Menu Options
SCREEN ADJ.
G
VGA MODE
ARC
PIP/DW
ZOOM
SCREEN
TO SET
Adjusting Horizontal/ V
Adjusting Horizontal/ V
ertical Position
ertical Position
1. Press the MENU button and then use
D
/
E
button to select the SCREEN menu.
2. Press the
G
button and then use D
/
E button to select SCREEN ADJ. .
3. Press the G button and then use
D
/
E
button to select V-POSITION or H-POSITION .
4. Press the
G
button and then use the
F
/
G
button to make adjustments until you get
desired horizontal or vertical position.
• The adjustment range of
V-POSITION is -50 ~ +50.
• The adjustment range of H-POSITION is -100 ~ +100.
• Based on the PC resolution, the adjustment range of V-POSITION/H-POSITION may
change.
• Based on input signal, the position of the picture may not change even though you
have adjusted the horizontal or vertical position with this function.
5. Press the MENU button.
Picture Phase
Picture Phase
Adjustments (RGB1 (PC) mode only)
Adjustments (RGB1 (PC) mode only)
1. Press the MENU button and then use D
/
E button to select the SCREEN menu.
2. Press the
G
button and then use D
/
E button to select SCREEN ADJ. .
3. Press the
G
button and then use D
/
E button to select PHASE .
4. Press the
G
button and then use the
F
/
G
button to adjust phase.
• The adjustment range of PHASE is 0 ~ 63.
5. Press the MENU button.
AUTO CONFIG.
V-POSITION G
H-POSITION
PHASE
RESET
SCREEN ADJ.
0
AUTO CONFIG.
V-POSITION
H-POSITION
PHASE G
RESET
SCREEN ADJ.
30