804546NZ - BW_HB Small_09.18 v1.02
Page 15 of 24
After installing a new filter, touch
[Flush Filter] to enter the
flush sequence (refer to the Filter Flush diagram on page 8).
Set the valve on the side of the unit to the “Filter Flush” posi-
tion (Fig.1 on page 8) and touch
[Next]
It is important for the valve to be in the “Filter Flush” position
to prevent water entering the boiling tank. Touch “Start” and
allow 5 litres of water to flow through the filter (this takes about
10min of flushing). Water must trickle out of the vent outlet (at
0.5L/min). Touch “Stop” when complete.
Touch
[Next] after flushing.
As prompted, return the filter valve to the “Filtered” position
(Fig.3 on page 8) and then touch
[Done].
Touch
[Done] after flushing is completed.
Menu Operation
Press
[Continue] to reset the filter counter.
2.4.3 SETTINGS - FILTER LOG
From the home screen touch
,
,
[Filter Log].
This is a record of when the filter was changed.
3 INSTALL MENU
From the home screen touch
,
,
[Install].
3.1 INSTALL – LIGHT CALIBRATION
This action adjusts the darkness threshold.
Light calibration is performed at normal (daylight) light level. A
suitable darkness threshold is calculated and stored for night
time low power mode (sleep mode).
From home screen touch
,
,
, [Light Calibration].
