P A G E 6
206-3491-O
Mini glossary
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
Antenna Hook Up
Connect an off-air antenna to the HealthView TV
If you have a 75 ohm RF cable, then you don’t need
any adapters.
A 300 to 75 ohm adapter is not included with the
Zenith HealthView TV.
300 TO 75 OHM
ADAPTER
ANTENNA
CABLE
M.P.I.
TV Back
Flat wire
(300 ohm)
Antenna
300/75 ohm
Adapter
TV Back Panel
(Expanded View)
PILLOW SPEAKER
TV
SPKR
PILLOW
SPKR
Video
In
Speaker
Out
Audio
In
ANTENNA
CABLE
M.P.I.
TV Back
Antenna
TV Back Panel
(Expanded View)
RF Coaxial Wire
(75 ohm)
PILLOW SPEAKER
TV
SPKR
PILLOW
SPKR
Video
In
Speaker
Out
Audio
In
Locate the Antenna/Cable jack on the back of
the HealthView TV.
Connect the antenna wire that runs from the
wall to this jack, according to one of the dia-
grams shown to the right.
Remove the back of the optional remote and
put in two AA batteries.
Plug in the TV. The HealthView TV is designed
to operate on standard current, 120-volt 60
Hertz AC. Do not attempt to operate it on DC
power.
Go to page 11 to Auto Program the TV.
Back of
Remote
1
2
3
4
5
