804545NZ - BW_AB Small_09.18 v1.02
Page 15 of 24
4.1 Install - Light Calibration
From the install menu choose
Continue
and
select
Before continuing ensure the unit is in its normal typical light
environment and the front panel is not covered.
Select
to perform the calibration. It will complete after 6
seconds.
Select
to continue.
4.2 Install - Boiling Calibration
This automatically corrects for boiling point differences at
each installation site. The unit was calibrated by the installer
at installation; however the installation environment may have
changed requiring recalibration of the boiling point.
Incorrect boiling calibration points may cause excessive
steam vent releases, or increased energy usage.
Boiling calibration is recommended when the temperature
setting is close to 100°C (section 3.2).
From the install menu choose
Continue
and
select
The unit will heat the water for boiling calibration. This
may take several minutes depending on the initial water
temperature. When it completes the screen will automatically
return to the install screen.
4.3 Install - Power Cycle
From the install menu choose
Power Cycle
and
select
This will turn the unit briefly off then on (restart). All custom
settings will be retained.
Choose
Continue
and select
to perform
the power cycle.
Menu Operation
