8
Parallelism may be disturb if cutting depth will be adjusted after adjusting parallelism.
Never unscrew the sleeve screws.
cuttinG proceDures
1. Place the saw body (base) on the work piece, and align the intended line of cut with
the saw blade, using the notch at the front of the base. This relationship of base to
work pieces should remain unchanged regardless of the inclination of the base.
2. The switch should be turned to the ON position before the saw blade comes into
contact with the work piece. The switch is turned ON when the trigger is pulled by
one’s finger, and is turned OFF when the trigger is released.
CAUTION
Before cutting check the material to be cut.
Before starting to saw, ensure that the saw blade has reached full speed revolution.
Should the saw blade be stopped or make an abnormal noise during operation, turn off
the switch immediately.
Always take care in preventing the power cord from coming near the revolving saw
blade. Wear eye protection. After operation disconnect the plug from the receptacle.
Mounting and dismounting the saw blade
WARNING
! To avoid serious accident ensure the switch is in the OFF position,
and disconnect the plug from the receptacle.
1. Dismounting the saw blade
• Set the cutting volume at maximum, and place the Circular Saw.
• Depress the lock lever, lock the spindle, and remove the hexagonal-flange bolt and
washer with the wrench.
• While holding the lever to keep the lower guard fully retracted into the blade cover,
remove the saw blade.
2. Mounting the saw blade
• Thoroughly remove any sawdust which has accumulated on the spindle, bolt and
washers.
• For mounting saw blade, the concave sides of both washers (A) and (B) must be
fitted to the saw blade sides. Mount the saw blade on the spindle, and finally affix
washer
• To assure proper rotation direction of the saw blade, the arrow direction on the saw
blade must coincide with the arrow direction on the blade cover.
• Using the fingers, tighten the hexagonal bolt retaining the saw blade as much as
possible. Then depress the lock lever, lock the spindle, and thoroughly tighten the bolt.
• Confirm that the lock lever is in the original position.
Maintenance anD inspection
1. Inspecting the saw blade
Since use of a dull saw blade will degrade efficiency and cause possible motor