4
cords intended for outdoor use.
20. Stay alert. Watch what you are doing.
Use common sense. Do not operate tool
when you are tired.
21. To avoid possible danger always use
battery charger, specified for this model.
22. When power cord of battery
charger is damaged, have it replaced by
authorized service center. Repair should
be performed only by specialists of
authorized service center. Manufacturer
doesn’t bear responsibility for any failures
or damage resulting from improper use or
unauthorized repair.
23. Do not charge at voltage higher than
indicated on the nameplate.
24. Always charge batteries before use.
25. Never use inappropriate batteries. Do
not connect ordinary dry battery, battery
pack different from designated battery,
or automobile battery to power tool. Do
not use any transformers with additional
devices and rectifiers. Do not charge
battery from electric generator or DC
power source. Never charge outdoors.
Keep the battery away from direct sunlight
and use only where there is low humidity
and good ventilation.
26. Check damaged parts. Before further
use of the tool, a guard or other part that
is damaged should be carefully checked to
determine that it will operate properly and
perform its intended function. Check for
alignment of moving parts, free running
of moving parts, breakage of parts,
mounting and any other conditions that
may affect its operation. A guard or other
part that is damaged should be properly
repaired or replaced by an authorized
service center unless otherwise indicated
in this instruction manual. Have defective
switches replaced by an authorized service
center. Do not use the tool if the switch
does not turn it on and off.
27. Warning Use only accessories
or attachments recommended in this
instruction manual or in the catalogue of
ZENIT ТМ.
28. Have your tool repaired by a qualified
person. This electric tool is in accordance
with the relevant safety requirements.
Repairs should only be carried out by
qualified persons using original ZENIT
TM spare parts. Otherwise this may result
in considerable danger to the user.
safety precautions on usinG
cordless drill
1. Always charge under temperature 5°C-
40°C. Temperature below 5°C may lead to
overcharge, which is dangerous. Battery
cannot be charged at temperature above
40°C. The most favorable temperature for
charging is 20°C-25°C.
2. Once the charging has been completed,
give 15 minutes rest until the next
charging. Never charge more than two
batteries in a row.
3. Never insert foreign objects into the
hole for the battery or the battery charger.
4. Never disassemble the battery and
battery charger.
5. Never short-circuit the battery. Battery
short circuit may result in the risk of fire.
6. Never incinerate the battery. The battery
can explode.
7. Before drilling into walls, ceilings or
floors, ensure that there are no concealed
power cables inside.
8. In case after charging battery life
becomes too short for practical use, take
exhausted batteries to the shop, where
they were purchased, for disposal. Do not
dispose of the exhausted batteries. Using
exhausted battery may lead to battery
charger damage.
