7
correctly.
5.Check the rotational direction
The bit rotates clockwise (viewed from
the rear side) by pushing the R-side of
the selector button. The L-side of the
selector button is pushed to turn the bit
counterclockwise.
CAUTION
When using the cordless drill follow these
rules:
• continuous use of the drill should not
exceed 15 minutes;
• do not allow mechanical damage (strikes,
falls etc.);
• protect the drill from external sources of
heat and chemically active substances, as
well as liquid and objects penetration;
• before disconnecting the tool from the
power source turn off the On/Off switch;
•check the engine temperature, do not
allow overheating;
•change the rotation direction only after
switching off the tool and complete stop
of rotating parts.
Inobservance of these rules will make
warranty void!
WARNING
Repair, modification and check of ZENIT
power tools should be performed only in
authorized service centers ZENIT. While
use or maintenance of power tools follow
all safety rules and standards.
NOTE
Zenit Power Tools are constantly being
improved and modified to incorporate the
latest technological advancements.
Accordingly, some parts may be changed
without prior notice.
torque you need.
CAUTION
Ratchet sound of the clutch dial for a long
period of time may cause screw breakage
due to excessive tightening.
3. Mounting and dismounting of the bit
• Mounting the bit
Loosen the sleeve by turning it toward the
left (in the counterclockwise direction as
viewed from the front) to open the clip on
the keyless chuck. After inserting a driver
bit, etc., into the keyless drill chuck, and
tighten the sleeve by turning it toward the
right (in the clockwise direction as viewed
from the front).
If the sleeve becomes loose during
operation, tighten it further.
The tightening force becomes stronger
when the sleeve is tightened.
• Dismounting the bit. Loosen the sleeve
by turning it toward the left (in the
counterclockwise direction as viewed
from the front), and then take out the bit
etc.
NOTE
If the sleeve is tightened in a state where
the clip of the keyless chuck is opened
to a maximum limit, a click noise may
occur. This is the noise that occurs when
the loosening of the keyless chuck is
prevented and is not a malfunction.
CAUTION
When it is no longer possible to loosen
the sleeve, use a vise or similar instrument
to secure the bit. Set the clutch mode
between 1 and 7 and then turn the sleeve
to the loose side (left side).
4.Confirm that the battery is mounted
