54
55
ENGLISH
54
55
ENGLISH
9. The monitor employs an automatic motorized mechanism. To prevent damage to the
core mechanism, please do not push, pull or swivel the monitor manually.
DISCONNECTING THE BATTERY
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery
cable prior to installation.
NOTE:
If the unit is to be installed in a car equipped with an on-board drive or navigation computer,
do not disconnect the battery cable. If the cable is disconnected, the computer memory
may be lost. Under these conditions, use extra caution during installation to avoid causing
a short circuit.
NOTE:
It is especially important that you read the
WARNINGS
and
CAUTIONS
in this manual.
■
Electrical tape
■
Crimping tool
■
Volt meter/test light
■
Crimp connections
■
18 gauge wire for power connections
■
16 – 18 gauge speaker wire
WARNING!
1. Only connect the unit to a 12-volt power supply with proper grounding.
2. Never install this unit where operation and viewing could interfere with safe driving
conditions.
3. To reduce the risk of a traffic accident (except when using the rear view video camera)
never use the video display function while driving the vehicle. This is a violation of law.
4. Never disassemble or adjust the unit without the assistance of a professional installer.
For further details, please consult your ZENEC dealer.
5. To prevent injury from shock or fire, never expose this unit to moisture or water.
6. Never use irregular discs.
7. To prevent damage to the mechanism inside this unit, avoid impact to the TFT monitor.
8. Do not change the fuse on the power wire without professional guidance. Using an
improper fuse may cause damage to the unit and result in a fire.
ZE-MC172 Manual D+E-CS3.indd 55
06.09.2007 11:14:08 Uhr