ZENEC ZE-160DVD, Instruction Manual

Page: 32 / 72

%N
28
Section Sec
Additional lnformation
Note:
• This unit is for vehicles with a 12-volt
battery and negative grounding. Before
installing it in a vehicle, truck, or bus,
check the battery voltage.
• To avoid shorts in the electrical system,
be sure to disconnect the battery cable
before beginning installation.
• Refer to the owner`s manual for details
on connecting the power amp and other
units, then make connections correctly.
• Secure the wiring with cable ties or
adhesive tape. To protect the wiring, wrap
adhesive tape around it where they lie
against metal parts.
• Route and secure all wiring so it cannot
touch any moving parts, such as the gear
shift, handbrake and seat rails. Do not
route wiring in places that get hot, such
as near the heater outlet. If the insulation
of the wiring melts or gets torn, there is a
danger of the wiring shortcircuiting to the
vehicle body.
• Don`t pass the yellow lead through a hole
into the engine compartment to connect
to the battery. This will damage the lead
insulation and cause a very dangerous
short.
• Do not shorten any leads. If you do, the
protection circuit may fail to work when it
should.
• Never feed power to other equipment by
cutting the insulation of the power supply
lead of the unit and tapping into the lead.
The current capacity of the lead will be
exceeded, causing overheating.
• When replacing fuse, be sure to use only
fuse of the same rating as indicated on
this unit.
• Speakers connected to this unit must be
highpower types with minimum rating
of 40W and impedance of 4 to 8 ohms.
Connecting speakers with output and/or
impedance values other than those noted
here, may result in the speakers catching
fire, emitting smoke, or becoming
damaged.
• When this product`s source is switched
ON, a control signal is output through the
blue/white lead. Connect to an external
power amp`s system remote control
or the car`s Auto-antenna relay control
terminal (max. 300 mA 12 VCD). If the car
features a glass antenna connect to the
antenna booster power supply terminal.
• When an external power amp is being
used with this system be sure not to
connect the blue/white lead to the amp`s
power terminal. Likewise, do not connect
the blue/white lead to the power terminal
of the autoantenna. Such connection
could cause excessive current drain and
malfunction.
• To avoid short-circuiting, cover the
disconnected lead with insulating tape.
Especially, insulate the unused speaker
leads with tape. There is a possibility
of short-circuiting if the leads are not
insulated.
• To prevent incorrect connection, the input
side of the IP-BUS connector is blue,
and the output side is black. Connect the
connectors of the same colors correctly.
09 0
ZE-160DVD Manual E neu-.indd Abs1:28 ZE-160DVD Manual E neu-.indd Abs1:28 07.09.2004 10:42:11 Uhr 07.09.2004 10:42:11 Uhr