6
11. Connect the main connection cable (No. 2) of the
ZENEC system (No. 1) to the two radio plugs on
the vehicle.
Depending on your vehicle, you must use either
the 20-pin (No. 3) or the 28-pin connector (No. 4)
to operate the AUX connector and the steering
wheel remote control. You must connect these to
the main connection cable.
The reverse gear signal is supported only by the
28-pin connector (No. 4). If your vehicle is fitted
with a 20-pin connector (No. 3), you need to use
a gauge to search for the reverse gear signal and
connect it directly to the main connection cable
(No. 2).
If you cannot find an ISO antenna plug in your
vehicle, it is most likely that your vehicle is using
a special Toyota antenna plug. If this is the case,
the set includes a FM ISO antenna interface (No.
6) which you can simply connect to the original
unit. If the antenna is active, you must also con-
nect the blue phantom power cable to the main
connection cable (No. 2).
12. Remove both screws from the transport lock
prior to installing the ZENEC system (No. 1).
13. (No picture)
Connect all cables previously installed in the
radio bay to the ZENEC system (No. 1).
14. Carefully route the various connection cables of
the ZENEC system in the lower section of the
radio bay. Then slide the ZENEC system careful-
ly into the radio bay by applying controlled force.
Screw it back into position with the four Phillips
(PH2) or hex (10mm) screws.
11
14
12
