4
Example of installation: Toyota Avensis 3G (Type T27)
Disassembly and preparation:
NOTE
1. Remove the ignition key and leave it outside the vehicle for the duration of installation.
2. Start with the uninstallation of the original unit.
3. Do not switch the ignition back on until all the points in the assembly manual have been completed
and the ZENEC system has been fully installed.
1. Lever the plastic cover on the right of the cen-
tre console out of its fixture, as shown in the
diagram. You require a plastic lever tool for this
step.
2. Lever the plastic cover on the left of the centre
console out of its fixture, as shown in the dia-
gram. You require a plastic lever tool for this
step.
3. To begin with, lever the radio cover/air vent noz-
zle upwards out of its fixture. Slide the lever tool
around the plastic frame once from right to left.
4. Remove the lower section of the cover from its
fixture. There is a connection for the hazard light
switch on the rear of the cover. You must dis-
connect this before removing the plastic frame
completely.
1
3
2
4
