2
COMPATIBILITY LIST
●
The installation of the ZENEC system should be carried out by an authorized installer.
Specific knowledge and tools are required to do the installation. Incorrect installation can cause
damage to the vehicle and the ZENEC system.
● Correct functioning can only be guaranteed when you use the ZENEC original accessories included
in the kit or optionally available. The ZENEC system and the original accessories must under no
circumstance be modified or altered. Inappropriate actions can cause damage to the
vehicle and the ZENEC system.
● Torx screwdriver T25
● Phillips screwdriver
● Release tool made of plastic
● Hand saw or equivalent
● File
● Insulating tape
● The target vehicle must offer factory provision for the installation of a radio. The ZENEC system is
not compatible with vehicles that are equipped with an OE radio or OE navigation system ex works.
● This device installation manual applies to vehicle platforms appearing in the above compatibility list,
and in a condition as offered by the respective vehicle manufacturer. Other differing configurations
and installations of motorhome manufacturers are not covered by this installation manual. If
you have questions or vehicle-specific problems please contact the relevant motorhome
manufacturer.
● The ZENEC system is equipped with an integrated DAB+ receiver. To make use of this tuner system
you will need a suitable DAB antenna (not included in kit) that must be connected to the ZENEC
system.
● If the target vehicle is equipped with a multifunction steering wheel, in order to support the steering
wheel remote functions a stalk interface is required (separate accessory).
● Software updates to the ZENEC system are installed with a USB memory device.
Therefore when fitting the system make sure that the USB connection of the ZENEC system
will still be accessible later (installation of USB extension cable or USB hub).
● If you have questions or problems relating to the ZENEC system, please contact the dealer from
whom you purchased it.
Model
Model Version
Model Year
FIAT Ducato III
250/251
2006 – 2011
FIAT Ducato III
250/251
2011 – 2014
FIAT Ducato III
250/251 (X290)
from 2014
Citroën Jumper II
250/250D/250L
from 2006
Peugeot Boxer II
250/251
from 2006
TOOLS REQUIRED
No. Article
Qty
1 ZENEC system
1
2 Mounting frame
1
3 Phillips screws
4
4 Remote control
2
5 microSD card with adapter
1
6 GPS antenna
1
7 Bluetooth microphone
1
THE KIT INCLUDES
8 Antenna adapter ISO/DIN
1
9 Main connection cable
1
10 USB extension cable
2
11 24-pin connection cable (4.2, MZone, AV-IN)
1
12 20-pin connection cable (Mic, Cam, IR-IN)
1
13 Connection cable parking brake
1
14 Metal plate for GPS antenna
1
15 Double-sided adhesive pad
1
CAUTION
NOTE
