74 Rev.A
75 Rev.A
COMMISSIONING
Make sure that the vehicle is located outside, and that the GPS reception is not adversely affected by
any shadowing (trees, high buildings etc.). Now insert the navigation software microSD card supplied
with the set into the microSD card slot of the ZENEC system, and start it in order to establish a sat
fix. Make sure that the vehicle is not moved until the sat fix is established. Now press the NAV button
to start the navigation mode, and choose map view. Once your present location can be seen in the
map view the sat fix has been established. This can take 3 to 5 minutes. You can now use the ZENEC
system.
Finally carry out a general functional test and perform the basic and car specific settings (AC, OPS
etc.). Also ensure that no fault warnings appear on the vehicle side.
OVERVIEW OF INCLUDED ACCESSORIES
No. Article
Qty
1 Main connection cable Quadlock II
1
2 CAN bus interface
1
3 24-pin connection cable (4.2, Cam, Mic)
1
4 FM antenna interface, single to twin Fakra converter cable for VW
1
5 DAB SMB to Fakra A converter cable
1
6
USB extension cable 1m
2
7
GPS antenna with cable and Fakra connector
1
8
Main device operating instructions booklet
1
9
Double-sided adhesive pad
1
10
Unlock tool
4
CONNECTION DIAGRAM Z-E2060
Z-E2060
DAB
HDMI
USB 2
USB1:
• Apple MFI
• USB Media Playback, -Smartlink Direct, -Software Updates
USB2:
• Apple MFI
• USB Media Playback, -Smartlink Direct, -Software Updates
A
GPS
UKW/
FM
USB 1
C
C
C24
C2
C23
C1
C1 Rear Monitor Out
C2 N.A.
C3 Camera IN
C4 Video IN
C5 AUX IN L
C6 AUX IN R
C7 Line Out Rear L
C8 Line Out Rear R
C9 Line Out Front L
C10 Line Out Front R
C11 Line Out Sub Woofer
C12 Line Out Sub Woofer
C13 MIC
C14 N.A.
C15 IR/IN
C16 GND
C17 N.A.
C18 12V (max 300mA)
C19 N.A.
C20 N.A.
C21 N.A.
C22 N.A.
C23 N.A.
C24 N.A.
A
B
A11 CAN TX
A12 P. ANT +12V** (Antenna)
A13 P. CNTR +12V** (Amplifier)
A14 Parking
A15 KL 31 / Power GND
A16 KL 30 / Per12V PWR
A17 Speaker Rear Right (-)
A18 Speaker Rear Right (+)
A19 Speaker Front Right (-)
A20 Speaker Front Right (+)
A1
CAN RX
A2 Reverse
A3
KL 15 / Sw12V PWR
A4
Illumination
A5
Analog Wheel KEY 2
A6
Analog Wheel KEY 1
A7
Speaker Rear Left (-)
A8
Speaker Rear Left (+)
A9
Speaker Front Left (-)
A10
Speaker Front Left (+)
B1
Speaker Rear Right (+)
B2
Speaker Front Right (+)
B3
Speaker Front Left (+)
B4
Speaker Rear Left (+)
B5
Speaker Rear Right (-)
B6
Speaker Front Right (-)
B7
Speaker Front Left (-)
B8
Speaker Rear Left (-)
B9
CAN High
B10 CAN Low
B12 GND
B15 B+
B17 AUX-L
B18 AUX-GND
B29 AUX-R
20 PIN CONNECTOR
(DEVICE BACKSIDE)
A1
A11
A10
A20
QUADLOCK II
CONNECTOR
B9
B10
B18
B17
B29
**
300mA max current
24 PIN CONNECTOR
