72 Rev.A
73 Rev.A
INSTALLATION NOTES
CAUTION
● The installation of the ZENEC system should be carried out by an authorized installer. Specific
knowledge and tools are required to do the installation. Incorrect installation can cause damage
to the vehicle and the ZENEC system.
●
Correct functioning can only be guaranteed when you use the ZENEC original accessories
included in the kit or those optionally available. The ZENEC system and the original accessories
must under no circumstances be modified or altered in any way. Inappropriate actions can
cause damage to the vehicle and the ZENEC system.
NOTE
●
The ZENEC Z-E2060 is equipped with an integrated DAB+ receiver. To make use of this you
will need a suitable DAB antenna (not included in this kit) that must be connected to the ZENEC
system.
●
If the target vehicle is already equipped with an original DAB antenna, it is still possible to use it
in combination with the ZENEC system.
●
Software updates to the ZENEC system are installed with a USB memory device. Therefore
when fitting the system make sure that the USB connection of the ZENEC system will still be
accessible later (installation of USB extension cable).
●
If you have questions or problems relating to the ZENEC system, please contact the dealer
from whom you purchased it.
REMOVAL WORK AND PREPARATION
NOTE
● Make sure that all connectors at the rear of the ZENEC system have sufficient room and are
not bent.
● Connectors without a retaining mechanism must be additionally secured with insulating tape.
NOTE
1. Remove the ignition key and keep it outside the car until the installation is finished.
2. Please wait for ca. 10 minutes until the CAN bus system is completely shut down, before
you start with the deinstallation of the original device.
3. Start with the deinstallation of the original device.
4. Please switch on the ignition only, when all work steps are done and the ZENEC system is
completely mounted.
GENERAL
ABBREVIATIONS
Abbreviation
Description
A2DP
Manufacturer-independent Bluetooth® technology allowing audio signals to be
transmitted (Advanced Audio Distribution Profile)
AF
Alternative frequency
DAB / DAB+
Transmission standard for terrestrial reception of digital radio (Digital Audio
Broadcasting)
DSP
The digital signal processor is used for the processing of digital signals (e.g.
audio or video signals)
EQ
Equalizer
FAT32
Formatting format for digital media
(File allocation table 32-bit)
UKW/FM
Transmission standard for terrestrial reception of very high frequency analog
radio (FM)
GPS
Global navigation satellite system for position fixing
(Global Positioning System)
GSM
Global mobile cellphone network standard for digital mobile networks
(Global System for Mobile Communications)
ID3-Tag
ID3 tags means meta data, which is contained in audio tracks of the MP3
format.
microSD
Compact flash memory
REG
Regional station
SSP
Secure Simple Pairing (for Bluetooth devices)
TA
Traffic Announcement (RDS service) of dedicated RDS radio stations
USB
A USB connection is a serial bus system for connecting a device to other
devices (Universal Serial Bus).
SWC
Steering wheel control
