1
4
4
3
2
EXAMPLE OF INSTALLATION GOLF VI
REMOVAL WORK AND PREPARATION:
3. Unscrew and remove the four Torx Screws
(T25) of the original device.
1. Gently lift the trim frame starting on the right
side of OE device. For successful completion of
this step, using a release tool made of plastic
tool is mandatory.
2. Run the prying tool anticlockwise around the
trim frame, to release it from the console. The
trim frame should come off of the console
completely.
4. Remove the original device by pulling it out of
the radio slot. Detach all the cables from its
backside.
1. Remove the ignition key and keep it outside the car until the installation is finished.
2. Please wait for ca. 10 minutes until the CAN bus system is completely shut down, before you start
with the deinstallation of the original device.
3. Now you can start with the deinstallation of the original device.
4. Please switch on the ignition only, when all work steps are done and the ZENEC system is
completely mounted.
NOTE
