Zelmer ZVC763 SERIES, User Manual

Page: 62 / 63

62
ZVC763-005_v01
Disposal
Dispose of packaging in an environmentally-
friendly manner. This appliance is labelled
in accordance with European Directive
2012/19/EU concerning used electrical and
electronic appliances (waste electrical and
electronic equipment – WEEE). The guideline
determines the framework for the return and recycling of
used appliances as applicable throughout the EU. Please
ask your specialist retailer about current disposal facilities.
If you do not clean the above-mentioned parts
or clean them insufficiently it may lead to the
loss of the filtration capabilities of the inserts
and foam and cause the formation of bacteria
and mites.
Dry all the cleaned parts thoroughly before
reassembly.
FILTER DISASSEMBLY
FOAM FILTER I
1 Open the lid of the filtration unit by pulling the handle
upwards.
2 Take out the filter, wash it under running water, dry and
reinsert.
●
Close the filtration unit lid by pressing it until you hear
a characteristic click.
FOAM FILTER II
It is recommended to wear rubber protective gloves while
dismantling the filter.
1 Grab the foam filter with your fingers and remove it from
the filtration unit body.
2 Wash under running water, dry and reinsert.
Do not hand wash the filter foam, do not wring
it, do not wash it in washing machines. Avoid
crumpling, stretching and deforming. After
cleaning dry the foam in room temperature.
Never dry the foam on heaters, stoves, etc.
HEPA H13 OUTLET FILTER AND COOLING AIR
FILTER
The HEPA H13 outlet filter should be replaced after about 30
hours of operation (6 months) or earlier in case of heavy dirt.
1 Slide the slider of the filter cover interlock downwards
and open the filter cover.
2 Remove and replace the HEPA H13 filter with a new one
when the filter becomes dirty.
3
Remove and replace the motor filter with a new one
when the filter becomes dirty.
4 It is possible to rinse the HEPA H13 filter and the cooling
air filter under running water. Remember to dry the above
mentioned filters before reassembly.
●
Close the filter cover and slide the interlock slider
upwards.
G
H
I
The manufacturer does not accept any liability for any damages
resulting from unintended use or inappropriate handling.
The manufacturer reserves his rights for modifying the product any
time in order to adjust it to law regulations, norms, directives, or due
to construction, trade aesthetic or other reasons, without notifying it
in advance.