Zelmer ZVC315HP, User Manual

Page: 64 / 64

70
ZVC315-001_v02
5 Insert the rinsed cone of “CYCLONE” dust container
into the container slot so the tip located on the flange of the
cone was in the slot of container’s body. Turn right the cone
so that the two tips located on the flange of the cone were
blocked in the slots of the container.
6
Snap the bottom of “CYCLONE” dust container. Please
pay attention to the proper positioning of seal found on the
bottom of the container.
7 Insert “CYCLONE” dust container to vacuum cleaner
chamber. The characteristic “click” indicates that the
container has been correctly mounted.
End of operation, cleaning and
maintenance
1 Switch off vacuum cleaner pressing On/Off switch (4) .
2
Put the connection cable plug out the wall outlet.
3 Wind the cable by pressing retractor button (6) .
Performing this action, hold the power cable to avoid any
tangles and shocking the vacuum cleaner body with the plug.
4 Disconnect telescopic suction tube and a sucker or
a brush sweeper.
5 Disconnect telescopic suction tube and a hose.
6
Press the two side buttons located at the hose end, then
remove the hose end from vacuum cleaner inlet hole.
7
Vacuum cleaner can be stored either in vertical or
horizontal position. The hose may remain attached to the
vacuum cleaner, but please note that the hose should not be
strongly bent during storage.
Storing in horizontal position:
–
Insert a fixing hook of sucker-brush sweeper to a hook
for fixing the sucker-brush sweeper located on the back
of the vacuum cleaner over the outlet filter cover.
Vertical storage:
–
place the nozzle brush on the telescopic pipe,
–
then insert the hook of the telescopic pipe into the
fastening situated on the bottom of the vacuum cleaner,
near the front wheel.
8 If necessary, clean the casing and the chamber of the
vacuum cleaner with a damp cloth (it may be damped in
dishwashing liquid), dry it off, and wipe it dry.
Do not use any scrubbing agents or solvents.
Examples of problems you may encounter
when using the vacuum cleaner
PROBLEM SOLUTION
A characteristic fluttering
in the vacuum cleaner is
heard.
• Check the CYKLON dust container
and other accessories. Remove the
reason for the clog-up or empty and
clean the CYKLON dust container.
• Replace or clean the filters.
G
The importer/manufacturer does not accept any liability for any
damages resulting from unintended use or improper handling.
The importer/manufacturer reserves his rights to modify the product
any time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in advance.
PROBLEM SOLUTION
The vacuum cleaner works
less efficiently.
Empty and clean the CYKLON dust
container, replace or clean the filters,
check the suction pipe, the hose, and
the nozzle – remove the reason for
the clog-up.
The cut-out of the
wiring system has been
triggered.
Check if there are any other devices,
besides the vacuum cleaner, plugged
into the same electrical circuit. If the
cut-out is triggered again, have
the vacuum cleaner repaired in
a servicing center.
The vacuum cleaner does
not work; the body or the
power cord is damaged.
Have the vacuum cleaner repaired in
a servicing center.
Ecology – Environmental protection
Each user can contribute to protect the environment. It is
neither difficult nor expensive. In order to do so:
Return cardboard packages to recycling points.
Throw polyethylene (PE) bags into appropriate
containers.
Return a worn out appliance to an appropriate
collecting point as the components of
the appliance may pose a threat to the
environment.
Do not dispose the appliance with the municipal waste!