32
GW33-023_v01
If the hair straightener is used in the bathroom,
●
always unplug it from the electrical outlet after use,
as it may pose a risk even when the appliance is
switched off.
Use the appliance only for its intended use as described
●
in this manual.
CAUTION: To ensure additional protection we advise
you to install a residual current device (RCD) in the
bathroom’s electrical circuit with the rated amperage
not exceeding 30 mA. In order to do so please contact
a qualified electrician.
WARNING: Do not use this appliance near
water, bathtub, pool or other water tank.
WARNING: Follow these safety instructions to avoid
the risk of burns, electric shock or fire.
Technical parameters
The technical parameters are indicated on the rating label.
ZELMER hair dryer fulfills the requirements of the existing
norms.
The appliance is in conformity with the requirements of the
directives:
Low voltage appliance (LVD) – 2006/95/EC.
–
Electromagnetic compatibility (EMC) – 2004/108/EC.
–
The appliance was marked by the CE sign on the rating label.
Product features
1
Straightening plates
2
Temperature display
3
Temperature adjustment:
„
+
” – temperature increase
„–
” – temperature decrease
4
ON/OFF button
5
Safety lock
6
Cord
1
5
6
2
4
3
How to use
PREPARATION
1
Wash hair and apply hair conditioner. Dry hair
thoroughly.
2
If hair is coarse, rough or very wavy apply straightening
lotion.
3
Brush or comb hair to comb out all knots.
OPERATION
1
Slide the safety lock towards the cord in order to unblock
the handles. If you forget to do this, it may be difficult to
release the safety lock while the appliance is heating.
2
Plug in the appliance.
3
Press and hold the
button for 5 seconds.
4
The display will light and it will show 130 (degrees
Celsius) and the “
Ready
” sign will begin to flash.
5
In order to change the temperature press the ”
+
” button
to increase the temperature and the “
–
” to decrease the
temperature. The maximum temperature is 230°C, the
minimum temperature is 130°C.
6
The “
Ready
” sign will stop flashing when the desired
temperature is reached.
