Zelmer 32Z010, User Manual

Page: 41 / 42

43
GW32-003_v02
it on the motor housing (12) so, that the protrusions in
bottom part of the jug (3) are fitted with the protrusions
top part of the motor housing (12) .
The handle (8) of the blender jug (3) shall be placed on the
right side of the appliance.
Ecology – environment protection
Each user can protect the natural environment. It is neither
difficult nor expensive.
In order to do it: put the cardboard packing into
recycling paper container; put the polyethylene
(PE) bags into container for plastic.
When worn out, dispose the appliance to
particular disposal centre, because of the
dangerous elements of this appliance, which
can be hazardous for natural environment.
Do not dispose into the domestic waste disposal!!!
Cleaning and maintenance (Fig. C)
1
Unplug from the mains supply outlet before cleaning.
Clean after operation as soon as possible, to prevent the
pulp accumulation inside the jug (3) .
2
To clean the jug and the blades it is recommended to
apply self-cleaning function. Pour about 1 litre of water into
the jug (3) and start up the appliance for approximately 30
seconds at lowest speed applying safety instructions. Then
empty the jug (3) , turn it upside down and dry it.
3 If necessary, clean the jug (3) , lid (2) , feeder opening
stopper (1) and blades (10) in warm water with wash-up
liquid. Then rinse it under clean running water and dry. At
first disassemble cutting unit (10) (see „Cutting unit disas -
sembling”).
If you left the jug for longer time without cleaning and
●
some particles glued to the jug inner, use nylon brush.
We do not recommend cleaning the jug
●
(3) , blades (10) ,
lid (2) and feeder opening stopper (1) in dish washer.
Aggressive cleaning agents applied in such device can
influence negative the surface conditions.
4
Clean the outsider of the motor housing (12) with damp,
gentle cloth.
Do not immerse the motor housing (12) in water
or other liquid.
Do not clean the outside of the housing
●
(12) with
aggressive detergents such as emulsion milk or pastes,
etc. They can remove information graphic symbols.
Do not clean the transparent jug
●
(3) with harsh sponges
or clothes.
After washing dry thoroughly all the parts of the
●
appliance.
CUTTING UNIT DISASSEMBLING
Unplug from the mains supply outlet.
●
Empty the jug (
●
3) .
Remove the lid
●
(2) from the jug (3) turning it clockwise
( „Open” position).
Turn the jug
●
(3) upside down and place the appliance on
flat, plain surface.
Turn the blocking ring counter clockwise. Remove
●
carefully with a gasket.
The cutting blades are sharp. Handle them
carefully.
CUTTING UNIT ASSEMBLING
Turn the blades upside down in order to assemble them
●
and insert at first the gasket at the jug opening flange (3)
and blades inside the jug (3) .
Insert blocking ring and turn it clockwise until it runs,
●
when the protrusion on blocking ring gets to the handle
(8) . Make sure that the blocking ring is screwed to the jug
(3) . It influences the tightness of the connection.
After assembling, turn the jug
●
(3) upside down and place
The manufacturer/importer does not accept any liability for any
damages resulting from unintended use or improper handling.
The manufacturer/importer reserves his rights to modify the product
any time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in advance.