Zelmer 28Z025, User Manual

Page: 67 / 72

67 GW28-022_v01
For stubborn wrinkles, wait a few seconds before pressing the – Burst of
Steam Button (3) again. Most wrinkles can be removed within three
presses.
After operation press and hold – button for about 2 sec-
onds to switch off the iron. You can hear single sound signal. Then the
display (5)
goes off.
Disconnect the iron from mains supply outlet. –
When the iron gets cool completely, store it vertically in a safe place. –
It may be necessary to press the burst of steam button a few times to
start this function.
For optimum steam quality, do not operate the Burst of Steam more
than three times in one cycle.
Hold the iron some centimetres away from delicate garments (artifi
-
cial, silk, velvet etc.), otherwise they can be damaged.
Build-in anti-scale system
The build-in anti-scale cartridge is designed to reduce the build-up of lime
scale that occurs during steam ironing. This will prolong the working life of
your iron, although it does not stop the natural process of build-up of lime
scale completely.
Self-cleaning
This function removes the scales and minerals built up in the Steam Cham-
ber. The iron will remain in the best condition if this function is performed
at least once a month or more regularly depending on the hardness of the
water used. You can see
on LCD display (5) .
Fill the water tank in as described under “ – How To Fill Water ”.
Place the iron on the surface in vertical, resting position. –
Connect the iron to a suitable mains supply outlet. –
The – display (5) glows for a moment and you can hear single sound sig-
nal. Then the display (5) go off.
Set the temperature – (9 - highest level) with
or buttons, as described in “ Temperature Setting ” item.
For stubborn wrinkles, wait a few seconds before pressing the – Burst of
Steam Button (10) again. Most wrinkles can be removed within three
presses.
After operation press and hold – button for about 2 sec-
onds to switch off the iron. You can hear single sound signal. Then the
display (5) goes off.
Disconnect the iron from mains supply outlet. –
When the iron gets cool completely, store it vertically in a safe place. –
It may be necessary to press the burst of steam button a few times to
start this function.
For optimum steam quality, do not operate the Burst of Steam more
than three times after the control light goes off.
Burst of steam in vertical position
– Always follow the garment
manufacturer’s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrinkles on delicate
garments in hanging position, hanging curtains, or other hanging fabrics.
Warning:
Do not apply steam on any clothes or fabrics that are being worn by
human or pets. Never direct the steam to human or pets.
Fill the water tank in as described under “ – How To Fill Water ”.
Connect the iron to a suitable mains supply outlet. –
The – display (5) glows for a moment and you can hear single sound sig-
nal. Then the display (5) go off.
Set the temperature – (5 level)
or higher with or but-
tons, as described in “ Temperature Setting ”
item.
The
– steam ironing indicator (B) ap-
pears on display.
The appliance is ready for operation. –
Hold the iron between 15 and 30 centimetres away from the garment. –
Press the – Burst of Steam Button (3) once – steam will shoot from
the holes of the soleplate. The steam penetrates the fabric removing
wrinkles.