Zelmer 28Z025, User Manual

Page: 65 / 72

65 GW28-022_v01
How to fill the water
Disconnect the iron from mains –
supply outlet.
Move the – steam Control Knob
(4) to position.
Release the – water inlet cover (8)
and fill water through the water
inlet hole.
Fill up to the „ – MAX ” level marked
on the side of water tank.
Close the – water inlet cover (8) .
Temperature setting
Connect the iron to a suitable mains supply outlet. –
The – display (5) glows for a moment and you can hear single sound sig-
nal. Then the display (5) go off.
Press the – button on the left side of the display, to switch
it on you can hear a single sound signal. Number, type of garment and
amount of dots referring to the temperature level.
To set the temperature use
– and buttons, located
at both sides of the display.
In order to increase the temperature press – button many
times (a sound signal goes with every click). The following labels shall
appear on display (5) : acrylic, nylon, silk, polyester, blend, wool, cotton,
jeans, linen.
In order to reduce the temperature press – button many times
(a sound signal goes with every click). The labels shall appear on dis-
play in reverse sequence.
Dots
– indicate the temperature setting.
Preparation for operation – first ironing
Remove any protective films or sticker from the – soleplate (1) and the
cabinet.
Unwind and straighten the – power cord (12) .
Fill the water tank in as described under “ – How To Fill Water ”.
The – display (5) glows for a moment and you can hear single sound sig-
nal. Then the display (5) go off.
Press – button to set the temperature on display
.
When the temperature is reached the number stops blinking and you –
can hear a single sound signal.
Move the – Steam Control Knob (4) to position.
Steam starts coming out from the holes in the sole plate after putting the –
iron in horizontal position and after Burst of steam knob (3) .
Begin first time ironing with an old towel. –
The steam is not generated after the water tank is emptied. –
The preparation work is completed. The iron is now ready for proper –
use.
After operation press and hold – button for about 2 sec-
onds to switch off the iron. You can hear single sound signal. Then the
display (5) goes off.
Move the – Steam Control Knob (4) to position.
Disconnect the iron from mains supply outlet. –
When the iron gets cool completely, store it vertically in a safe place. –