9
Important Safety Warning
PLEASE NOTE COOLING
SYSTEM HAS BEEN
UNPLUGGED FROM BACK OF SWITCHBOARD
(Leave for cooling contactor to insert into switchboard).
Do not try plug cooling system plug into
switchboard until cooling system has been
commissioned by qualified air con contractor
PLEASE ENSURE THERE IS POWER TO
THE ZELLABOX (SWITCHBOARD) BEFORE
COMMISSIONING THE COOLING SYSTEM
5.1
Condenser
Depending on the model and cooling capacity
the condenser maximum distance can vary between 20
and 30 meters. The Zellabox is supplied with relevant
cable length (3 core orange output to condenser & 4 core
grey cable. The condenser draws its power from the
Zellabox. The condenser size and weight can also vary
depending on model and cooling capacity.
The condenser will be positioned either on
the outer wall of the building or on the roof.
5.2
Commissioning
Once the Zellabox has been positioned in its
proposed location and connected to power
the air conditioning contractor can commission
the cooling system.
Only once the air conditioning contactor has
Connected wires to the condenser and plugged the
grey and orange cable into the Zellabox, can the
cooling be turned on.
ENSURE THE COOLING SYSTEM PLUG IS
PLUGGED INTO THE CORRECT POWER
SOCKET ON THE SWITCHBOARD
5.3 Wiring
The Zellabox is supplied with all the cables (orange and grey)
which is pre-coiled and ready to be run with the
copper piping during the commissioning process.
The pre-coiled condenser cables are located inside the Zellabox.
CONTRACTORS TO ENSURE BOTH ORANGE AND GREY
CABLES ARE LOCKED BY TURNING THE YELLOW DISK ON THE
SIDE OF THE CABLE PLUGS WITH A SCREW DRIVER.
THE COOLING / AIR CONDITIONING CONTRACTOR MUST
SUPPLY COPPER PIPING.
Zellabox
Safety
Instructions
5 Single & Dual cooling
system
commissioning
steps:
Wiring table (White Cable)
1- Live
Red / Brown
2 - Neutral
Blue / Black
3 - Signal
White
Green / yellow
Earth / Ground
