Zeizz Primo Star, Operating Manual, Page: 16 / 306

Carl Zeiss Start-Up and Operation Primo Star / Primo Star iLED
16
M60-2-0011 v 08/2008
En
g
lish
3.1.2 Mounting the reflected-light
fluorescence illuminator
Mounting the reflected-light illuminator onto
the stand
•
Remove the tube, see section 3.5.1. If the
clamping screw is used to fix the tube to the
stand, replace it by the Allen set screw.
•
Insert the magnetic field transmitter (Fig. 7/ 1 )
for interlock as far as it will go into the stand at
the rear strut and screw it down.
•
Push the carrying handle (Fig. 7/ 3 ) from the
back into the stand and fix it with two screws
(Fig. 7/
2 ).
•
Insert the reflected-light illuminator (Fig. 8/ 1 ), in
right angle and slightly inclined with its dovetail
mount into the stand (Fig. 8/
4 ).
•
Position the reflected-light illuminator (Fig. 8/ 1 )
horizontally and turn it backwards with the
dovetail mount in the stand, align it to the
outer edges of the stand and tighten the set
screw (Fig. 8/
3 ).
If the outer edges of the reflected-light
illuminator are not exactly aligned to
the stand, it may be that the reflected-
light illuminator cannot be switched on
due to the interlock feature causing
the interruption of the circuit to
protect against emergent LED light.
•
Place the tube onto the stand and tighten the
clamping screw (Fig. 8/
2 ), see section 3.5.1.
Fig. 7 Mounting the magnetic field
transmitter and the carrying handle
Fig. 8 Placing the reflected-light
illuminator onto the stand